Unfortunately no one can be told what FluxBB is - you have to see it for yourself.
You are not logged in.
For the Mi-T-M Pressure Washer Certified Technician. In case your Kerosene Portable Heater will not be firing, there might be a pair reasons causing this issue. Check to make sure the air pump filters are clear. Check for a gap(s) in the air hose that connects the air pump to the burner nozzle. If you don't discover any holes, take away and examine the air pump rotor for cracks and harm. Replace the air hose or air pump rotor based mostly on the basis of the cause. When changing the air pump rotor, you could set the proper hole at the highest of the carbon rotor. To do this have the rotor in place and the outer steel ring unfastened, then place the .004 inch gauge between the highest of the rotor and the underside of the outer ring. Tighten the bolts in the steel ring. Next, rotate the air pump rotor clockwise and recheck the .004 inch air hole each 1⁄4 turn from the same high location. Reset the outer ring if any locations are lower than .004 inch. Disconnect the igniter wires from the control board and examine for voltage on the management board. The voltage will have to be checked within 1 - 3 seconds of turning the Alpha Heater news on/off swap to the on position. The voltmeter ought to read 120 volts AC. If there is no voltage, you might want to substitute the management board. If voltage is present on the management board, that signifies that your igniter is more than doubtless the difficulty and you might want to substitute it.
Here is my web site; Alpha Heater news
Offline